Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You may locate that your garage door opener has been providing you troubles, so you require to fix it. You can fix it by changing a motherboard, a photo-eye sensing unit, the main drive gear, or the set-limit buttons. You can also examine if the safety sensors are functioning appropriately.

Replacing a circuit card

Changing a circuit card for your garage door opener requires a few steps as well as devices. First, you need to switch off the circuit breaker as well as detach any kind of cords. Next off, open up the motherboard cover. This will certainly assist you to detect the problem as well as establish if you need a new board. Next off, eliminate the old board as well as its cord adapters.

You can after that proceed to change the circuit card. The replacement process is easy and also takes around 10 minutes. A new circuit board will certainly cost regarding $80. To secure your brand-new motherboard from power surges, you can acquire a surge protector.

Changing a photo-eye sensing unit

Changing a photo-eye sensor can be a rather straightforward task. Initially, get rid of the sensor from the door as well as see to it is located properly. If the sensor is angled whatsoever, it might not be obtaining the appropriate signal, which could be creating the blinking lights. If you observe that the photo-eyes are out of positioning, you may require to have a technician come and also fix the problem.

The photo-eye sensor contains two pieces that mount outside of the door tracks and towards the flooring. The picture eyes will certainly have a little LED light as well as need to be solid in color. If the light is blinking, its most likely the photo-eye is defective and also will require to be replaced.

Changing a major drive gear

To replace a garage door opener major drive equipment, start by eliminating the cap from the chain pulley-block. Next, eliminate the two screws holding the drive gear to the sprocket assembly. Now, you can loosen the three tension pins. Squeeze them from both sides and afterwards eliminate them. After that, disconnect the three cords from the garage door opener electric motor. These wires must be white, red, as well as blue.

When you have actually gotten rid of the old gear, mount a brand-new one. Make sure to oil it well. Insert the new gear right into the shaft, ensuring to align the installing openings. Make certain the equipment and gear setting up are positioned properly to make certain smooth operation. Next, use a hammer as well as a nail to drive a pin right into the new gear.

Adjusting the set-limit switches

The initial thing you should do if your garage door is not functioning appropriately is to examine the set-limit buttons. You may require to readjust them so that the door closes earlier or stops before it gets to the floor. You can check this by taking a look at your garage doors manual or online.

To readjust the set-limit buttons, youll require a screwdriver or socket. Readjust the knob clockwise or counterclockwise until the door moves up as well as quits, or minimizes its distance. To check for proper travel range, determine the void from the bottom of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Main St Ste 105, Keller, TX 76248, USA

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

Leave a Reply

Your email address will not be published. Required fields are marked *


Back To Top